Turn the adjusting screws until the blade edge just contacts the triangular rule.Learn the tools applications and limitations, as well as the specific potential hazards peculiar t o KEEP GUARDS IN PLACE and in working order.A n undersized cord will cause a drop in line voltage resulting correct size t o use depending on cord length and nameplate ampere rating.
Turn off the planer-jointer and then clean out chips w i t h a stick. Do not touch blades right after operation, they may be extremely hot and could burn your skin. However, allow some spacing between the stock t o permit the feed rollers t o grip the thinnest piece. Positioning the planer-jointer Locate the tool in a well lit and level place where you can maintain good footing and balance. ![]() CAUTION Workpieces with the following dimensions cannot be fed into the auto-planer because the interval between the two feed rollers i s 114 mm (4-12). Install it on the outfeed table and semi-tighten the four hex bolts. Extend the legs arms over the screw using the hook Then tighten the screws securely. Adjust the table height using the knobs so that the extension support table i s level with the outfeed table. Loosen the clamp screws ( A ) and (B) and pull the fence out slightly. Loosen the hex bolts ( A ) and (B) and tilt the fence according to your work. REPLACING THE PLANER BLADES Dull blades can cause a rough finish, an overload of the motor and dangerous kickback of the workpiece. This tool is equipped with either throw-away blades or standard blades. Place the two magnetic holders on the set plate and push them in the direction of the arrow until the claw contacts the blade. Remove the eight blade installation bolts using the socket wrench. Grip the magnetic holders and slip the heel of the plate into the groove in the drum. Rotate the drum slowly while pressing the lock plate to make sure there i s nothing abnormal. ![]() Lower the infeed table fully by turning the depth adjusting knob clockwise. Loosen the hex bolt which secures the safety cover rod and lift off the safety cover. Place the blade and plate on the wood block so that the blade locating lug of the set plate rests in the groove of the blade. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |